EMAK efco BLE 506 Betribs- Und Wartungsanleitung Seite 61

6.4 | LUBRICATION
Lubricate the machine according to figure 6.4 and the table below. In the event that the machine is operated in very dusty or sandy
operating conditions, lubricate more frequently.
Ball bearings of the tension pulleys, guide pulleys and bearings on the mowing deck are self-lubricating.
Prior to starting lubrication, the engine must be turned off and all moving parts of the machine must be still.
Symbol
50
(1)
(2)
(3)
(4)
6.4
(5)
(6)
(7)
(8)
(9)
(10)
(11)
Do not allow oil and lubricants to come into contact with the drive belts and their pulleys. Thoroughly wipe the area around the
lubricated parts before and after lubricating.
Prior to putting the machine out of operation for an extended period of time, thoroughly lubricate all locations shown on the picture,
particularly however the half shafts of the front and rear axles.
Plastic lubricant A00
Interval in hours
Rotating central pin of the axle housing
Bearings of both front wheels and pins of the axle housing
Angle joint connecting steering draw rods
Rotating points of pedals on both sides of the machine
Bolt of the mowing deck elevation draw rod
Half axles of the rear wheels (transmissions)
Steering draw rod ball pan
Rotating points of the mowing deck elevation mechanism
Cogged steering segment, eccentric and angle joint of the steering
Front wheel pin
Angle joint connecting steering draw rods
Explanation
Oil SAE 30
draw rod
61
Activity
---
---
---
Lubricate through oiler
Lubricate through oiler
Remove and lubricate
Lubricate without removing
Lubricate without removing
Remove the wheel and
lubricate
Lubricate without removing
Lubricate without removing
Lubricate without removing
Lubricate through oiler
Remove and lubricate