EMAK efco BLE 506 Betribs- Und Wartungsanleitung Seite 35

3.3.1 SEAT, STEERING WHEEL AND BATTERY
a) Fit the seat sliding mechanism and the mounting bolts:
► Tilt out the seat console (1) by approximately 90
the seat sliding mechanism (2), place a plate (4) against one side of the console and bolts (3) with washers on
3.3.1a
the other side.
► Also prepare plate (5), underlay (6) and bolts for attachment
b) Attach the seat to the tilting console
► Slide the seat on to the bolts and tighten the bolts fully.
► Tilt the seat down to the working position and using the sliding mechanism lever, set the appropriate seat
3.3.1b
position for your body size.
c) Connect the cable of the safety switch:
► Connect the electric cable to the switch connector on the underside of the seat.
3.3.1c
d) Install the steering wheel:
► Seat the steering wheel on to the shaft (1) and turn it so that the holes in the steering wheel and the shaft align.
► The steering wheel has two height positions, select the appropriate height for your body size. Then insert the
3.3.1d
supplied pin (2) into the hole and knock it in using a hammer.
e) Connect the battery:
► Loosen the bolts on the pole terminals of the battery.
► Place the red wire on the (+) pole of the battery and secure in place with the bolt.
3.3.1e
► Place the brown wire on the (-) pole of the battery and secure in place with the bolt.
- Connecting the wires in opposite to that described above will damage the machine.
- When disconnecting the battery, always disconnect the negative (–) pole of the battery first.
- When putting the battery into operation and when performing maintenance on it, proceed according to the instructions in the
user's manual for the battery. Also follow all safety instructions contained therein.
The battery is located in the compartment under the steering wheel.
In exceptional cases, it is possible that for transportation reasons, the bumper bar of the machine is released and slides back
towards the seat. In such a case, proceed as follows:
f) Fit the bumper bar in the correct position:
► Open the hood.
► Slide the bumper bar consoles away from the seat – the correct position is clearly marked on the frame.
3.3.1e
► Properly tighten the bolts of the consoles on both sides of the machine and close the hood.
upwards. Into the edge of the inner hole of the console, insert
o
35