Main Power Switch; Parking Brake Lever; Cruise Control - EMAK efco BLE 506 Betribs- Und Wartungsanleitung

(7) MAIN POWER SWITCH

Serves to start up / shut off the engine. It has the following 4 positions:
STOP
(8) BUZZER
After the sound signal indicating a full grass catcher, the mowing deck is not disengaged!

(9) PARKING BRAKE LEVER

If the lever is in the braking position, never push it down by hand. Always step on the brake pedal

(10) CRUISE CONTROL

Cruise control is only used when travelling in a long straight line. Before any change in direction it is necessary to deactivate the
cruise control.
(11) CHOKE
Enables the starting of a cold engine.
Ignition off / turn off the ignition
STOP
Turn on / turn off the headlights on the hood
Ignition on, the engine is running.
Start engine – starting position
The buzzer makes a sound signal when the grass catcher is full
The parking brake has two positions. In the pushed in position the brake is not engaged, after
pulling it up while stepping down on brake pedal the parking brake is engaged (will brake).
Stepping on the brake pedal will disengage the parking brake and the lever will automatically
be released and shift to the pushed in position.
Cruise control is active only when the ignition is turned on.
Engaging cruise control:
1. Set the speed by stepping on the forward travel pedal.
2. Pull out the cruise control upwards.
3. Take your foot off the forward travel pedal
Disengaging cruise control:
Step on the brake pedal or the forward travel pedal.
Machines with 2V (V TWIN) engines are not equipped with a separate choke, with the
exception of motors with an electronic choke.
43