EMAK efco BLE 506 Betribs- Und Wartungsanleitung Seite 50

5.5.3 TRAVELLING SPEED AND MOWING GRASS
► It generally applies that the wetter, higher and more dense the grass is, the lower the travelling speed that should be used.
When the machine is travelling at high speed or when under large load, the rotation speed of the blades is reduced, the quality of
the cut is worse and the ejection chute may become clogged. Under such conditions always set the engine to maximum power.
► If the grass is very high, it is necessary to mow it several times. First mow at maximum elevation and with narrower mowing
coverage width if necessary. The second run can then proceed at the required mowing height.
► In the event that the 110 cm mowing deck is used for mulching, it is necessary to very carefully adjust the speed to the height
of the mulched vegetation respecting the significant load that this can place on the engine in this mode! The higher the grass, the
lower the travelling speed.
► We recommend mowing in the parallel or cross direction. Covering the previous coverage of the machine increases the
effectiveness of the blades and will improve the appearance of the mowed area.
► When travelling over uneven terrain the travelling speed may fluctuate.
Recommended travelling speeds of the machine based on conditions:
Condition of vegetation
High, dense and wet
Average conditions
Low, dry vegetation
Travelling without the mowing deck engaged
5.5.4 TRAVELLING ON A SLOPE
The 105J - 106 - 110 - 124 riding mower may work on slopes
with an incline of up to 12° (21%), when 4x4 drive is used, the
slope incline must to be greater than 15° (27%).
When working on a slope it is necessary to adhere to the
following fundamentals:
► Pay increased attention when travelling on a slope.
► Always use a slower travelling speed.
► Only travel perpendicular to the contour, i.e. up and down.
Travelling in the direction of the contour is possible with
extra attention only when turning the machine. If at all
possible, avoid travelling along the contour.
► When turning ensure that a wheel does not drive over an
elevated obstacle (rock, tree root, etc.)
► Travel slower when travelling down a slope or over
obstacles. Pay special attention when turning and turning
around on slopes.
► If you stop on a slope, always use the parking brake.
When overloading the machine by travelling on slopes over the aforementioned values, there is a risk of serious damage to the
transmission. The manufacturer is not responsible for damage caused in this way.
Recommended speed
50
2 km/hour
3 – 5 km/hour
< 5 km/hour
< 8 km/hour
Right
Wrong