Shimano STEPS E8000 Originalbetriebsanleitung Seite 93

5.5 Activating push assistance
Push assistance helps you when you are pushing the bike.
WARNING
Push assistance may only be used when pushing the pedelec.
Otherwise you could seriously injure yourself. Push assistance is not
designed to be used when someone is sitting on the pedelec.
Push assistance helps you when pushing the bike (up to
max. 6 km/h). This is particularly helpful when you want to
push your pedelec uphill. Push assistance can be activated
from any mode.
1. Press and hold the button until GO is
displayed.
If it is not possible to switch to GO mode, a warning sound
will be heard. This can occur for example when the bicycle
is underway, or when pressure is being exerted on the
pedals.
For 1. Keep the button pressed
2. Release the button once GO is
displayed.
3. Press and hold the button again
to activate push assistance. Push
assistance remains active as long as
the button is pressed.
If the bicycle is not moved once GO has been activated,
push assistance deactivates automatically. To activate GO
mode again, release the
hold it again.
If the button is not pressed for one minute or longer, the
support mode which was activated before switching to GO
will appear once again.
4. To quit push assistance, release the button and press the
briefly. The support mode which was activated before switching to GO
mode will now be displayed.
Intelligent push assistance
Intelligent push assistance is activated when an electrical switching
system (XT Di2, XTR Di2) is connected. The system provides individual
drive assistance in order to recognise the gear ratio. The function provides
the rider with greater torque on sharp inclines in low gear.
Original User Guide | Pedelec Shimano Steps E8000 Version 1
km/h
WALK
For 2. Push assistance display
button briefly and then press and
button
EN-33