Shimano STEPS E8000 Originalbetriebsanleitung Seite 73

DANGER
Only use original replacement parts. Replacement parts from other
manufacturers can impair the function of your pedelec. Serious acci-
dents can result.
Ask your cycle dealer to show you how to use, and explain, the
special features of the components. Please also follow the component
guides. We recommend asking your cycle dealer to assemble and
adjust the bike. Otherwise, components could become loose due
to a faulty assembly. If this happens whilst you are cycling, you
could injure yourself very seriously or even die. If you do have to
tighten something yourself, a full list of torque settings is in Section
 10. Torque settings Page EN-59
requirement).
WARNING
Do not ride in unfavourable lighting conditions (fog, rain, dusk,
darkness) without adequate lights
to do so can result in accidents and serious injuries.
Always switch off the pedelec and unplug the motor plug on the motor
before starting work on the pedelec. You risk being seriously injured
if the system is still switched on.
1. Switch off the pedelec using the button.
2. Remove the motor casing.
3. Unplug the round power supply plug on the motor.
(strict adherence to which is a
 IV.II.I Lights Page EN-8. Failure
CAUTION
Do not open up the motor, display, battery or charger as you could
injure yourself. Parts might also be damaged beyond repair,
invalidating the warranty. Contact your cycle dealer when problems
arise.
IMPORTANT
Always park your pedelec so that it cannot tip over. Components can
be damaged if the bike tips over. If your bike is not equipped with
a kick stand, one can be fitted if required. Please contact your cycle
dealer.
Do not clean the pedelec with a water hose or high pressure washer.
Although the components are sealed, damage to the cycle may still
result. Clean the pedelec with a soft damp cloth.
Handle the product with care and avoid heavy shocks.
Original User Guide | Pedelec Shimano Steps E8000 Version 1 EN-13