Shimano STEPS E8000 Originalbetriebsanleitung Seite 85

Replacing the front wheel
1. Insert the wheel into the front fork ends.
2. Gently turn the adjustment nut on
the quick-release lever in a clockwise
direction.
3. C lose the quick-release lever by
swinging the lever back 180˚.
You will now usually be able to see the
word 'CLOSE' on the outside of the
lever.
DANGER
It should be hard enough to close the quick-release lever that you
need to use the ball of your hand (120 N: corresponds to a weight
force of 12 kg). You should have the mark of the lever imprinted on
your hand. Otherwise it could open when you are cycling, which could
lead to the wheel becoming loose and cause you to fall.
1. Open the quick-release lever.
Quick-release lever is too
2. Turn the adjustment nut clockwise.
easy to close
3. Swing the quick-release lever closed again.
4. Repeat if necessary.
1. Open the quick-release lever.
Quick-release lever is not
2. Turn the adjustment nut anticlockwise.
easy to close
3. Swing the quick-release lever closed again.
4. Repeat if necessary.
*dependent on model
Adjustment nut
Quick-release lever
For 3. Close the quick-release lever
Quick-release levers cannot be closed by simply turning the
lever.
DANGER
If you have released the rim brakes to remove the wheel, you must
close them again, otherwise you will not be able to brake and run the
risk of serious injury.
3.9.3 Wheel with axle shaft
Removing the front wheel
1. Switch off the pedelec.
2. O pen the quick-release lever on the
front wheel by turning it down 180˚.
3. Hook the quick-release lever into the slot and turn it anticlockwise
until the quick-release axle protrudes from the axle hole about 1 cm.
4. L ift out the front wheel and remove the quick-release axle.
Original User Guide | Pedelec Shimano Steps E8000 Version 1
*
Quick-release lever
For 2. Open the quick-release lever
EN-25