Shimano STEPS E8000 Originalbetriebsanleitung Seite 116

Description Cause
No display a) No power
b) The battery is not sufficiently charged.
c) The battery is charging.
d) The display is not properly mounted on the bracket.
e) The power cable connector is not properly connected.
f) A component which the system does not recognise has been
connected.
Three acoustic signals are This indicates an error or a warning.
heard.
There is signal interference.
Two audible signals are heard The operation of the pressed button has been deactivated.
when the assistance button is
pressed. In addition, it is not
possible to press the button.
9.3 Battery
Description Cause
The battery does not charge. a) T he battery charger plug is not firmly inserted into the socket.
a) T he battery charger charging connector is not firmly inserted
into the battery.
c) Damaged battery.
d) Battery charger is faulty.
EN-56 Original User Guide | Pedelec Shimano Steps E8000 Version 1
Remedy
a) Press the button.
b) Charge the battery and try again.
c) T he system cannot be switched on when the battery is charging. Wait until the battery
is completely charged, or interrupt the charging process.
d) Install the bicycle computer correctly.
e) Check whether the power cable connector which connects the motor unit to the drive
unit is disconnected. If you are unsure, contact your dealer.
f) Contact your dealer.
Follow the instructions relating to the relevant code.
This is not a fault. Turn off the signal.
This is not an error.
Remedy
a) U nplug the battery charger power plug from the socket. Reinsert the plug. Repeat the
charging process. If it is still not possible to charge the battery, contact your dealer.
b) U nplug the battery charger charging connector from the battery charging socket, and
reinsert. Repeat the charging process. If it is still not possible to charge the battery,
contact your dealer.
c) Damaged batteries must not be charged or used for any other purpose. Contact
your cycle dealer. The battery may have to be replaced.
d) Have your charger checked out by your cycle dealer; it may have to be replaced.