Single-Screw Supports: Shifting And Tilting The Saddle; T Win-Screw Supports - Shimano STEPS E8000 Originalbetriebsanleitung

3.3.1

Single-screw supports: Shifting and tilting the saddle

1. Loosen the clamping screw by turning it
anticlockwise. Turn the screw completely
two to three times at most or the whole
mechanism could fall apart.
2. Move the saddle backwards or forwards as
required.
3. Tilt the bicycle saddle to the desired angle.
4. Tighten the clamping screw by turning it clockwise with a torque
wrench.
5. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
3.3.2 Twin-screw supports: Shifting and tilting the saddle
DANGER
Screw the clamping screws fully in a straight position in the nuts.
Failure to do so can result in the screws tearing out of the nuts.
correct
Clamping screw
1. To move the saddle, loosen the front
2. Move the saddle backwards or
For 1. Loosen the clamping screw
3. Tighten the screws using a torque wrench to turn them clockwise.
4. To alter the angle of the saddle, loosen the front screw by turning it
5. Tighten the front screw by the same number of turns.
6. Ensure that the newly-tightened saddle does not tip; test it by pressing
wrong
and rear screws by turning them
anticlockwise. Turn the screws
completely two to three times at
most or the whole mechanism could
fall apart.
forwards as required.
anticlockwise. Turn the screw completely two to three times at most or
the whole mechanism could fall apart.
down on the front and back alternately.
Original User Guide | Pedelec Shimano Steps E8000 Version 1
For 1. Loosen screws
EN-19