Switching On The Pedelec - Shimano STEPS E8000 Originalbetriebsanleitung

For 2. Charging the battery
3. Insert the mains plug into a power socket. The green LED on the
charger flashes continuously
blue.
4. The charger switches off once the battery is fully charged. The green
LED on the charger is continually on . The button on the top tube is
lit blue.
If the charger remains connected to the battery, the charger
regularly checks whether the battery is still fully charged.
The LED on the battery charger then begins to flash green
again. After checking and ascertaining that the battery is
full, the charger switches back and is continuously lit.
5. Remove the power cable from the socket after completing the charging
process.
6. Remove the charging cable from the charging socket on the top tube.
EN-30 Original User Guide | Pedelec Shimano Steps E8000 Version 1
Charging socket on down tube
. The button on the top tube is lit
5.2

Switching on the pedelec

DANGER
Only ride the pedelec when you can safely reach the brakes
Braking Page EN-21.
IMPORTANT
Do not put your feet on the pedals when switching on the system. This
can cause system errors.
If error W013 appears, please switch the system off and on again –
after removing your feet from the pedals.
The system can only be activated if the battery is sufficiently
charged.
1. Press and hold the button until the
Switching on from Sleep mode (waking up)
If the bicycle has not been used for more than
2 hours, press the button on the top tube for
three seconds. Wake-up is indicated by the
brief flashing of the button before System
start-up. Please press the button for three
seconds. An acoustic signal is heard. The
Shimano Steps logo appears on the display
monitor, followed shortly thereafter by the
main page.
 3.6
button is lit blue.
Display button
button