Shimano STEPS E8000 Originalbetriebsanleitung Seite 118

9.5 Gear changes
Description Cause
No gear is displayed. The gear is only displayed when the electronic gear shift is in use.
When using an electronic gear The pedal assistance is set to an optimum level by the computer.
shift, pedal assistance seems to
be weaker when changing gears.
A noise can be heard after
changing gear.
A noise can be heard from the Gear changing is not set correctly.
rear wheel during normal riding.
When you bring the bicycle to a Excessive pressure is being applied on the pedals.
stop, the gear does not move to
the Start mode position.
The front or rear lights do not E-TUBE PROJECT may be set incorrectly.
light, even when the button is
pressed.
EN-58 Original User Guide | Pedelec Shimano Steps E8000 Version 1
Remedy
Check whether the power supply cable is disconnected. If you are unsure, contact your
dealer.
This is not an error.
Please contact your cycle dealer.
a) Mechanical gear shift: Adjust the tensioning of the gear shift cable.
b) Gear shifting: Please contact your cycle dealer.
Only apply gentle pressure to the pedals when changing gear.
Please contact your cycle dealer.