Receipt Of The Unit And Storage; Reception; Equipment Identification; Transport Damage - Ingeteam INGECON SUN String Control 320 Handbuch Für Montage Und Betrieb

Ingeteam

4. Receipt of the unit and storage

4.1. Reception

Keep the unit in its packaging until immediately before installation.

4.2. Equipment identification

The serial number (S/N) of the unit is its unique identifier. You must quote this number in any communication with
Ingeteam.
The unit's serial number is marked both on the packaging and on the nameplate.

4.3. Transport damage

If the unit has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within five days of receipt of the unit.
If ultimately the unit has to be returned to the manufacturer, you must use the original packaging.

4.4. Storage

Failure to follow the instructions shown in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, the following points should be taken into account in order to
avoid damage:
• Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
• Keep it away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
• Units in storage must not be subjected to weather conditions other than those indicated in Section "2.6.
Specification table".
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.

4.5. Conservation

In order to permit correct conservation of the units, you must not remove them from their original packaging until it
is time to install them.
In case of prolonged storage, the use of dry places avoiding, as far as possible, sharp changes in temperature is
recommended.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation.

4.6. Unpacking

Correct handling of the units is vitally important in order to:
• Prevent damage to the packaging which enables them to be kept in optimum condition from shipping
until they are installed.
• Avoid knocks and/or falls which may harm the mechanical characteristics of the units, e.g. cause incorrect
closure of doors, loss of IP rating, etc.
50
Receipt of the unit and storage
AAS2011IQM01_ - Installation and usage manual