17. Special functions / SETUP
Call up special function:
Press and hold the special function button 1 (next to MODE/MATERIAL) for 5 seconds
until the PARAMETER appears ('Setup' is shown in the upper displays).
With the left dial (pos. 2), the desired special function can be selected (►) and confirmed with the button
'ENTER/ OK' (pos. 12).
The selection allows the following special functions:
17.1 Copy/Delete Jobs
Individual jobs can be deleted with this function.
In the menu under "Reset" (pt. 8), all the jobs can be deleted at the same time.
With the left dial (pos. 2), the desired job can be selected (►) and confirmed with the button 'ENTER/ OK' (e.g.
pos. 002).
By pressing the special function button 2, under delete' the confirmation prompt YES or NO appears.
By pressing YES, the job is deleted, NO cancels the process.
17.2 Password
With this function, only the use of the special functions / setup menu can be locked.
ATTENTION: If the password is forgotten, this menu cannot be opened anymore!!
This is useful if the functions block (next point) is activated.
The password can be set between 001 and 999 with the right dial (pos. 5).
By pressing the button ENTER / OK (pos. 12), the password is saved.
If the next time the special functions / Setup menu is called up, the password has to be entered and confirmed
with the ENTER / OK button (pos. 12).
In order to deactivate the password block, repeat the process and enter 000 as a password.
With that, the password lock is deactivated.
17.3 Functions Block
Here, individual functions can be locked for users.
With the left dial (pos. 2), the desired special function can be selected (►) and the value can be changed with
the right dial (pos. 5).
Block type:
None
Level 1 [1]
Level 2 [2]
User [C]
(Shown in display, e.g. [1])
17.4 Advanced Selections / language
Here, various functions can be switched on and off.
With the left knob (pos. 2), the desired special function can be selected (►) and the value can be changed with
the right knob (pos. 5).
Language:
ADV WELD:
Cool Mode:
Gun load:
W.L.SPD:
17.5 Working indo / energy consumption
With the left dial (pos. 2), the desired special function can be selected (►).
Under this point, the following operational times can be read:
Arc on Timer :
Time welder on :
Energy saving:
Operating manual
Special
function
button 1
– All functions are unlocked
– All functions are locked except for the welding power and the arc length
– All functions are locked
– Here, individual parameters locks can be configured.
Welding power
Arc length
Process change
Program change
Job change
German – English – French – Italian – Spanish
Menu point 6, Show / hide 'weld extras'(enabled / disabled)
Always on or on demand (the cooling unit is detected automatically)
Inch wire by pressing the torch trigger (yes or no)
Determine speed for wire feed in (standard 8.0 m/min)
Welding time in 0 dd (days) 0:00:00 (HRS:Min:Sec)
Machine time in 0 dd (days) 0:00:00 (HRS:Min:Sec)
Normal – middle – high: Thereby, the power consumption can be reduced in
stand-by mode. The display is switched off quicker.
Special
function
button 2
(I./W.SPEED) in %
(Arc L./V)
in %
(Process C)
Disabled/Enabled
(Program C)
Disabled/Enabled
(Job Change)
Disabled/Enabled
ProPuls 330,400,500
Page 47