Fx / Parameter Description Of The Welding Processes Tig / Electrode; Welding Process / Material Selection - Jackle ProPuls 330 Betriebsanleitung

• 4-step crater-fill program with secondary current I2:
Functions like the 4-step standard welding crater-fill program.
Additionally, the welding power can be swapped between I1 and I2 by pressing the torch trigger for less
than (< 0.5s) whilst welding.
The current slopes from I1 to I2 with the I2 start ramp time, and stays at this level I2. When the torch
trigger is once more pressed for < 0.5s, the power slopes back to the main current I1, with the I2 end
ramp time. This process can be repeated as often as desired.
• Double pulse welding process:
Here, in addition to a pulsed arc, a further pulsing between 2 pre-set power settings can be activated.
The extra parameters are shown the welding crater-fill diagram.

16.4 Fx / parameter description of the welding processes TIG / Electrode:

The parameters can be called up using the Fx button and
changed with both dials.
Function:
Selection with the left
Rotating knob (Pos. 2)
HOTSTART
ARCFORCE
Slope up
Slope down
End voltage
Pulse overcurrent
Pulse Balance
Pulse Frequency

16.5 Welding process / material selection

By repeatedly pressing the button, the desired function can be selected.
Welding process (MODE):
With the left dial (pos. 2), the desired process can be selected (►) and called up with the button 'ENTER/ OK'
(pos. 12).
The follow welding processes can be selected:
Operating manual
Display text
HOT START
ARC FORCE
UP SLOPE
DOWN SLOPE
SWS V. LIMIT
PULSE DELTA
PULSE BAL.
PULSE FREQ.
• MIG PULSE
• MIG DOUBLE PULSE
• MIG/MAG SYNERGIC
• MIG/MAG MANUAL
• COLD CSt (option)
• PIPE (option)
• POWER ARC (option)
• FAST ARC (option)
• MMA (electrode)
• TIG LIFT
• TIG PULSED LIFT ARC
• JOB (only available after allocating jobs)
F
X
Range-values
Selection
with the
right
rotating knob
(Pos. 8)
50 0 – 100%
50 0 – 100%
0.0s 0.0 – 2.0s
2.0s 0.0 – 8.0s
0 -30 - +30
-50% -100 – 1000%
0% -40 – 40%
100Hz 0.1 – 500Hz
ProPuls 330,400,500
●
●
● ●
● ●
● ●
●
●
●
●
Page 44