Jackle ProPuls 330 Betriebsanleitung Seite 54

APPLICATIONS
- welding of thin sheet with low heat input
- welding of steel and stainless steel
- MIG brazing with a low level of heat input
- Optimal root welds
Power range: 20A – 200A
Curves: Steel 0.8/1.0/1.2mm , stainless steel (Cr-Ni) 0.8/1.0mm , Cu-Si3 0.8mm
PIPE
The PIPE arc is a modified short-circuit arc that has been developed especially for root welds in all positions.
The welding programs included within the scope of supply allow an extremely high level of quality, power and
gap bridging characteristics, even if the various root gaps have to be worked on. The process allows a TIG or
electrode welded root quality with a shorter welding time.
ADVANTAGES
- perfect and safe root welding in a vertical up or down position
- higher welding speed with respect to TIG or electrode welded root
- precise arc control when welding pipes and sheets with the desired thickness and in all positions.
- clear reduction of heat input into the welding seam joints
- simple welding process, simple to learn and to operate
- constant level of quality
APPLICATIONS
- pipe root welding
- sheet root welding
Power range: 30A – 170A
Curves: Steel 1.0/1.2mm , Flux cored (metal powder) 1.2mm
POWER ARC
The POWER ARC is a modified innovative arc that has been especially developed for deep fusion penetration
and long stickout.
The welding programs included within the scope of supply allow a concentrated arc full of pressure that could be
used everywhere, where a deeper fusion penetration, longer stickout (gap) or a narrow/smaller seam joint
preparation is required.
Advantages
- safer and deeper penetration with a higher rate of deposition
- higher welding speed in relation to normal spray arc
- Reduced angle weld preparations possible
- saving of wage, material, gas and energy costs
- optimal side wall fusion and therefore, less undercut
- easy manipulation
- virtually spatter free
Applications
- medium to heavy workpiece thicknesses
- steel, stainless steel and Aluminium processing operation
- automated and manual usability
Power range: 70A – 330/400/500A
Curves: Steel 1.2mm , stainless steel (Cr-Ni) 1.2mm
FAST ARC
The FAST ARC is a modified innovative arc that has been especially developed for high welding speeds for steel
and non-ferrous metals.
By means of magnetic influences, a very narrow arc reduces the heat input into the material and therefore
reduces material distortion and rework.
The welding programs included within the scope of supply allow a high level of welding power in short and mixed
arcs.
Operating manual
ProPuls 330,400,500
Page 51