Material Table; Special Welding Programs Cold/Root/Power/Fast (Option) - Jackle inoMIG 350 Betriebsanleitung

30. Material table

The following materials are in the control unit:
Material Display MC
Steel *
Steel *
Steel *
CrNi 4316 – ER308
CrNi 4576
ALMG 5
ALSi 5
CuSi 3
Metal flux-cored
wire *
T424 MC2 H5
Basic flux-cored
wire
T424 BC4 H5
Rutil flux-cored
wire
T422 PC1 H5
* Special welding programs, perhaps Option (see chapter 31)
31. Special welding programs COLD/ROOT/POWER/FAST
(option)
CSt: Power reduced cold short-arc (Cold Steel):
The COLD arc is a modified short-circuit arc that has been developed especially for welding thin sheets, root
beads and for MIG brazing in all positions.
The welding programs included within the scope of supply allow a very high level of welding quality to be
achieved with an optimised arc and minimal change to metallurgical properties.
BENEFITS
- gap bridging (also vertical down)
- low heat input
- low distortion
- reduced risk of burn through fall-through of the smelt
- welding of materials with high levels of carbon as well as high-alloyed steels
- no damage to the zinc coating when MIG brazing
- saving material and energy costs
- good controllability in overhead
APPLICATIONS
- welding of thin sheet with low heat input
- welding of stainless steel and thin aluminium sheets
- MIG brazing with a low level of heat input
- Optimal root welds
Power range: 20A – 200A
Material Display MC
Steel
Operating manual
Gas
St Argon 82%, CO
St Argon 90%, CO
St CO
2
4316 Argon 98%, CO
4576 Argon 98%, CO
ALnG Argon 100% (Ar)
ALSi Argon 100% (Ar)
CuSi Argon 100% (Ar)
nEPU Argon 82%, CO
bASi Argon 82%, CO
ruti Argon 82%, CO
Gas
CSt Argon 82%, CO
Display MC
18% - MIX 18 Ar82
2
5%, O 5% Ar90
2 2
Co2
2% - MIX 2 Ar98
2
2% - MIX 2 Ar98
2
Ar
Ar
Ar
18% - MIX 18 Ar82
2
18% - MIX 18 Ar82
2
18% - MIX 18 Ar82
2
Display MC
18% - MIX 18 Ar82
2
inoMIG 350/400
Wire diameter / mm
0,8-1,0-1,2-1,6
0,8-1,0-1,2-1,6
0,8-1,0-1,2-1,6
0,8-1,0-1,2
0,8-1,0-1,2
1,0-1,2
1,0-1,2
0,8-1,0
1,2
1,2
1,2
Wire diameter / mm
0,8-1,0-1,2
Page 46