C) Setting The Control Stick Positions - Reely X250 Bedienungsanleitung

• Check the connection by clicking "Flight data" in the bottom line in the software (see figure 35, item 2). If you move
the racecopter now, the virtual quadrocopter shown in the software (figure 35, item 1) must move accordingly.

c) Setting the Control Stick Positions

Since the flight control is pre-programmed, the required settings are limited to adjustment of your remote control to
the stick positions.
Enter the menu "Configuration" (figure 36, item 2) and select the button "Input" (figure 36, item 1) there.
Now check if your stick movement at the transmitter goes from "min" to "max" in the software. The changes to the stick
position are displayed "live" in the software. Updating can take a few milliseconds!
The flight mode switch must reach positions 1, 2 and 3 to work properly.
When you have set everything, you can save your settings with "Save" (figure 36, item 3).
Disconnect the racecopter from the power supply and the USB connection. You can close the programme.
Take the racecopter into operation as described in chapter 10; the function test and trim must, of course, be performed
according to the operating instructions of the remote control system used by you.
The software of the CC3D-flight control offers a great many options. It will pay off to deal with this in more
detail, to adjust the racecopter to your needs.
2
1
2
1
Figure 35
3
Figure 36
75