Reely X250 Bedienungsanleitung Seite 231

For installation of the camera, place the racecopter on a level surface to install the FPV system.
Disconnect the LiPo flight battery entirely from the racecopter before installation. Take it out of the battery holder.
Proceed with care for installation and do not apply any force.
To install a camera, remove the four screws (2) from the spacers (4, 5) at the top of the racecopter. Remove the as-
sembly (3) and the camera holder (1) from the racecopter.
Insert the camera into the camera holder (figure 27, item 1) so that the writing is legible when the two tabs in the
camera holder point up (see figure 28).
Attach the camera with the enclosed sheet bracket and the two screws in the camera holder. If the camera is not firmly
placed in the holder, remove the sheet bracket again and bend it into a slight U-shape so that the bent side will push
onto the camera housing and fasten it this way.
70
2
1
3
4
5
Figure 27
1
Figure 28