Setting Up The Transmitter; Inserting The Batteries - Reely Sky Roller Bedienungsanleitung

9.

Setting up the Transmitter

In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
The power supply of the transmitter requires 2 AA/mignon batteries (e.g. Conrad Item No.: 652506, please order 2x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
Loosen the attachment screw (1) of the battery com-
partment lid (2) at the back of the transmitter with a
suitable screwdriver.
Push the latching lever (3) of the battery compartment
lid down slightly and fold open the battery compartment
lid.
Insert two mignon batteries into the battery compart-
ment according to the indications at the bottom (4) in
the correct polarity. The spiral-shaped spring contact
(5) always must be connected to the minus pole of the
battery.
Replace the battery compartment lid in the transmitter
housing and let the latching lever latch.
Then tighten the attachment screw again.
36
Figure 2