Setting Up The Drone And Gesture Remote Control; Charging The Batteries - Reely SKYRIDER Bedienungsanleitung

8. Setting up the drone and gesture remote control

The drone and remote control batteries can be charged using the USB cable provided.
The charging cable is wound up. Before first use, remove the cable tie and fully unwind the charging cable.
a) Charging the batteries
As shown in the adjacent diagram, connect the USB connector on the charging cable to a USB port on a computer/
laptop or a USB charger plug.
Insert the connector on the charging cable into the connection plug on the remote control or drone.
When the drone or remote control is charging, the red LED indicator lights up on the USB connector. The LED indica-
tor will turn off when the rechargeable battery is fully charged.
The remote control battery takes 25 minutes to charge, while the drone battery takes 55 minutes.
Disconnect the rechargeable battery from the charging cable immediately after charging and remove the USB connec-
tor on the charging cable from the computer/laptop or charger plug.
Important!
Do not connect the USB cable to a USB hub without its own power supply (e.g. a USB port on a keyboard), as the
current is not sufficient to charge the battery.
The operating system will not detect any new hardware when the charging cable is connected, as the USB port is only
used to charge the battery. Please note that most USB ports on computers/laptops are only active when the computer/
laptop is switched on.
We therefore recommend that you only connect the charging cable to a computer/laptop that is switched on.
Important!
Only charge the rechargeable batteries using the USB charging cable provided. Never attempt to charge the battery
with a different/incompatible charger! Only charge the battery when you are able to monitor the charging process.
Important!
21