Putting The Rc System Into Operation - Reely X FACTOR RTR Bedienungsanleitung

4 P
REPARATION
4.4
S
TARTING THE
- Remove lid of battery compart-
ment on the lower side of the
transmitter.
- Insert 8 AA (rechargeable) batte-
ries in the compartment,
observe the correct polarity!
- Close the lid again
- Carefully connect both red plugs.
- Place the battery support with the
cables and the plug in the battery
box again.
- Screw the battery box back onto
the chassis without pinching the
wires.
- Push the lower end of the antenna
guiding tube into the outlet of the
antenna wire.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
© REELY 05/07
RC I
NSTALLATION
- Loosen the 2 screws of the battery
box on the chassis and take off
the battery box.
- Remove the battery support from
the battery box.
- Open receiver box and carefully
remove the receiver
- Unwind the wire of the antenna
and guide it outwards through the
opening in the cover of the
receiver box.
- Screw the receiver box back onto
the chassis
- Switch the transmitter on.
The blue LED in the leg of the
transmitter should light up.
If the LED does not light up, check
batteries /rechargeable batteries
and replace them, if necessary.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.
- Guide the antenna of the receiver
through the antenna guiding tube
- and guide it out at the other end.
- Switch on the receiver with the
switch on the RC-box.
The servos must turn in neutral
position.
Always switch ON the transmitter
first then the receiver.
First switch OFF the receiver,
then the transmitter.
41