4Wd Monster Truck Chassis; 4Wd Monster Truck Chassis - Reely X Factor Rtr Bedienungsanleitung

3 D
ESCRIPTION OF THE MODEL
3.2
4WD M T C
ONSTER RUCK HASSIS
2/4 WD
2/4 Wheel Drive driven by 2 or 4 wheels.
ABC assembly
ABC means "Aluminum", "Brass" and "Chrome". Aluminum with its small thermal expansion and small weight serves as
material for pistons, the cylinder is made of brass with chrome-plated contact surface.
Air filter
The air filter is made of foam and prevents the penetration of dust and dirt particles through the suction hole into the carbu-
rettor and in the engine.
Alignment
a b
Position of the wheel level to the driving direction:
a) Toe-in – Wheels point inwards
b) Toe-out – Wheels point outward
All-wheel drive
The suspension of the rear axis is completely symmetrical to the suspension of the front axis. This also gives you the pos-
sibility to install a servo here to control the rear wheels. However, you need a third remote control channel for this purpose.
Axle leg
This is where the axle turns. The steering levers are located on the front axle legs.
Bumper
made of aluminium, reaches far up, with screwed on aluminium cross-ties and plastics supports for an ideal dampening in
������������
�����������
the event of a frontal crash.
Chassis
The "frame" of the vehicle, to be precise, only the bottom support plate.
CVD drive shaft
A shaft which on one side engages the attachment on the differential with a steel pin and which on the other side is connected
to the axle without tolerance via a cardan joint, leading to low wear.
In this way the wheel can turn even at a great steering angle (strongly angled shaft).
Damper plate
The upper end of the shock absorber of an axle right and left is screwed to the damper plate at the front or at the rear.
The shock absorbers are thus somehow interconnected via the damper plate.
36
Operating Instructions 4WD Monster Truck Chassis X-Factor Item No. 23 42 40