Siemens SINUMERIK 840D sl Installationshandbuch Seite 969

Datei system.ini
# -------------------------------------------
# SIEMENS KEYBOARD-DRIVER SECTION (START)
# -------------------------------------------
# State of driver after startup
# (0=NORMAL, 1=PERMANENT-SHIFT ACTIVE)
keybStartState=0
# Type of Keyboard to be used
# (0=MMC103, 1=MFII)
keybType=0
# Filtering Key Sequences
# =======================
# Activation of Key-Sequences to be ignored
# SeqAct holds a BIT-Pattern for a max of 20 sequences
# which could be ignored by the keyboard-driver
# if bit-n is set in Seq-Act, the according sequence
# will be ignored
# The following 20 sequences are implemented
# 0 CTRL-ALT-DEL
# 1 ALT-F4
# 2 ALT-TAB
# 3 LEFTSHIFT-ALT-TAB
# 4 RIGHTSHIFT-ALT-TAB
# 5 CTRL-ESC
# 6 ALT-ESC
# 7 ALT-SPACE
# 8 (SHIFT)-CTRL-F1
# 9 (SHIFT)-CTRL-F2
# 10 (SHIFT)-CTRL-F3
# 11 (SHIFT)-CTRL-F4
# 12 (SHIFT)-CTRL-F5
# 13 (SHIFT)-CTRL-F6
# 14 (SHIFT)-CTRL-F7
# 15 (SHIFT)-CTRL-F8
# 16 M$_1
# 17 M$_2
# 18 CAPSLOCK
# 19 NUMLOCK
# 20 (reserved)
KeySequencesEnable =1
PCU-Basesoftware (IM8)
Inbetriebnahmehandbuch, 02/2012, 6FC5397-1DP40-3AA0
2.3 Anwenderspezifische Einstellungen beim Hochlauf
System konfigurieren
53