Assembly Instruction - AsViva RA6 O Benutzerhandbuch

ASSEMBLY INSTRUCTION

BEACHTEN SIE:
Place all parts form the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed.
NOTE: Don't remove or damage the DEACL(111) located on the top of the MAIN FRAME(1).
The DECAL(111) is for preventing from the Sensor Wires drop into the Upright Tube.
NOTE: For shipping purpose, CARRIAGE BOLTS(M8x70mm)(81) and NYLOCK NUTS(M8)(104)
will already be attached to the FRONT STABILIZER (2).
1. Remove CARRIAGE BOLTS(M8x70mm)(81) and NYLOCK NUTS(M8)(104) from the FRONT
STABILIZER (2).
There is a "R" decal on one end of the FRONT STABILIZER(2). Attach the FRONT STABILIZER(2)
onto the MAIN FRAME(1) with the "R" decal end at right side and secure with CARRIAGE
BOLTS(M8x70mm)(81) and NYLOCK NUTS(M8)(104).
2. Remove BUTTON HEAD BOLT(M8x15mm)(94) from the bottom of the MAIN FRAME (1).
Insert the STOPPER TUBE(48) through the MAIN FRAME(1) and secure with BUTTON HEAD
BOLT(M8x15mm)(94).
3. Insert the PEDAL SHAFT(44) through the MAIN FRAME(1). Place the RIGHT FOOT PEDAL
ASSEMBLY(46R) onto the right end of the PEDAL SHAFT(44) and place the LEFT FOOT PEDAL
ASSEMBLY(46L) onto the left end. Secure the FOOT PEDALS with BUTTON HEAD BOLTS
(M8x15mm)(94) and LARGE WASHERS(M8)(109) at both ends of the PEDAL SHAFT(44).
NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x15mm)(94)
at both ends of the PEDAL SHAFT(44) at the same time.
STEP 1
59 / 96