AsViva RA6 O Benutzerhandbuch Seite 62

ASSEMBLY INSTRUCTION
STEP 4
NOTE: The RIGHT PEDAL(41) has R stamped on the end of the pedal shaft. The RIGHT
PEDAL(41) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has
L stamped on the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is
tightened by turning counter clockwise.
1. Thread the RIGHT PEDAL(41) onto the RIGHT CRANK(37) located at inside of the CRANK
COVER(35) as shown. Tighten the pedal securely. Select the RIGHT PEDAL STRAP(42) which has
R marked on the bottom side of the strap. Snap the three hole end onto the inside edge of the
RIGHT PEDAL(41). Snap the other end onto the outside edge of the RIGHT PEDAL(41) with the R
mark on the bottom of the RIGHT PEDAL STRAP(42). Select adjustment holes which allow your foot
to be easily removed from the pedals. Do the same way to attach the LEFT PEDAL(39) onto the
LEFT CRANK(36) and snap the LEFT PEDAL STRAP(40) onto the LEFT PEDAL(39).
2. Refer to the inset drawing. Plug the PULSE SENSOR WIRE(73) into the socket of PULSE COIL
WIRE(74) located on the SEAT CARRIAGE(64). Plug the PULSE COIL WIRE(74) into the socket of
PULSE CONNECTION WIRE(75) located on the bracket on the MAIN FRAME(1).
62 / 96