AsViva RA6 O Benutzerhandbuch Seite 68

METER INSTRUCTION
During workout (after pressing
SPEED, DISTANCE and CALORIES, or RPM, ODO (Odometer) and WATT
MODE
DISTANCE and ODO (ODOMETER) information:
RPM, ODO, WATT will show at the same time SPEED, DISTANCE, CAL. will show at the same time
e. PULSE RECOVERY button measures how quickly you return to a resting hear rate after
exercising. You could use this button to measure
improvement as you get into shape
f. The console will monitor your pulse for 60 seconds and
calculate a HEART RATE RECOVERY value from F1.0
to F6.0. F1.0 is best; F6.0 is worst (For Reference Only)
PULSE
g. The readout should only be used as a comparison
RECOVERY
between workouts. It's recommended to use right after any aerobic exercise. Stop

exercising before starting the function.
h. Your pulse will be displayed approximately few seconds after the heart symbol "
displayed
NOTE:
If you don't hold the HEART RATE SENSORS on the
handrails with both hands properly, the console's HEART
RATE value would show "0" and the main screen would
show "F6.0" after the console counts down to zero, which
means the HEART RATE SENSORS won't be able to pick

up the signals. Press any keys to stop the long beep sound, then press PULSE RECOVERY
button again and make sure to hold the HEART RATE SENSORS on the handrails with both
hands properly this time.
START/STOP
DISTANCE:
e. This measures the total distance from 0 to 999 km/Mile.
START/STOP
f. After pressing
again to pause all functions and DISTANCE value during your exercise program.
g. Press
continue counting up until the program finish
h. The console would automatically shut off after 4 minutes of inactivity. The
DISTANCE value's counting will restart from zero after pedaling or pressing any
keys to active the console again
ODO (ODOMETER): The function of ODO and DISTANCE are similar will accumulate
the total distance traveled by the item during workout. If there is any necessary to reset
ODO's distance value, press UP
let the motor automatically calibrate to reset ODO value to zero
START/STOP
), the user could press
, DISTANCE will count up. Press
again to resume the program and DISTANCE value will
, MODE, DOWN
MODE
to select
START/STOP
and ENTER at the same time to
68 / 96
" is