AsViva RA6 O Benutzerhandbuch Seite 76

METER INSTRUCTION
"3"
Normal way to operate PROGRAM (P2~P7)
d. START/STOP
"A."ENTER MANUAL PROGRAM
button:
e. UP or DOWN
If you have selected other program (P1 or P8 ~ P16), pressing
UP or DOWN
program
f. ENTER
ENTER
Press
button:
Press button to confirm and enter
"B. SET THE DESIRED TIME or DESIRED DISTANCE
To avoid the user to select TIME and DISTANCE in the same program to confuse the user couldn't
distinguish which one (TIME or DISTANCE) as the first priority. User could only select TIME or
DISTANCE in the same program, one at the time
UP or DOWN
If you would like to select TIME value, not
DISTANCE value:
button:
PROGRAM (P2 ~ P7)
c. After pressing the
UP or DOWN
mode will appear with the display flashing "0:00"
d. Use
TIME (1:00 TO 99:00; 1 MINUTE INCREMENT)
NOTE for TIME:
Count Up: If a target time was not selected,
TIME will count up from 0:00 to maximum 99:59
minutes
Count Down: If you have set the target time, the
console will count down from that selected
target time down to 0:00


(P2~P7)"
PROGRAM (P2 ~ P7)
button:
button to select
ENTER
button to enter into
, the TIME function
buttons to set the desired
START/STOP
PROGRAM (P2 ~ P7)
ENTER
If you would like to select DISTANCE value, not
TIME value:
button and then
PROGRAM (P2 ~ P7)
a. After pressing the
mode will appear with the display flashing "0:00".
b. Press the
UP
function mode will then appear with the display
flashing "0.0"
c. Use
DISTANCE (1 TO 999KM/MILE; 1 KM/MILE
INCREMENT)
NOTE for DISTANCE:
Count Up: If a target distance was not selected,
this would measure the total distance from 0:00
to 999 km/mile
Count Down: If you have set the target distance,
the console will count down from the selected
target time down to 0


button to pause the current
UP or DOWN
ENTER
button to enter into
ENTER
, the TIME function
button again, the DISTANCE
or DOWN
buttons to set the desired
button:
76 / 96