AsViva RA6 O Benutzerhandbuch Seite 61

ASSEMBLY INSTRUCTION
STEP 3
NOTE: Be careful not to damage the PULSE SENSOR WIRES(73,74) while doing assembly STEP
1 to STEP 3.
NOTE: For shipping purpose, BUTTON HEAD BOLTS (M8x12mm)(114) will already be attached to
the SEAT CARRIAGE (64).
1. Remove BUTTON HEAD BOLTS (M8x12mm)(114) from the SEAT CARRIAGE (64).
Attach the HANDRAIL(70) onto the SEAT CARRIAGE(64) with BUTTON HEAD BOLTS
(M8x12mm)(114).
2. Attach the SEAT(68) onto the SEAT CARRIAGE(64) with ROUND HEAD BOLTS(M6x15mm)(95).
Attach the BACK CUSHION(69) onto the SEAT CARRIAGE(64) with ROUND HEAD BOLTS
(M6x30mm)(96).
3. Turn the knob of the SPRING PIN(67) counterclockwise and lock the knob in the release position,
refer to the insert drawing. Slide the SEAT CARRIAGE ASSEMBLY(64) onto the RAIL(52).
Press the RAIL CAP(55) into the back end of the RAIL(52). Insert the STOPPER BOLT(54) through
the RAIL(52) and RAIL CAP(55) to bolt them together with the STOPPER(53). Please verify that the
other STOPPER BOLT(54) at the front end of RAIL(52) was assembled at the factory.
61 / 96