Assembly Instruction - AsViva RA6 O Benutzerhandbuch

ASSEMBLY INSTRUCTION

NOTE:
Place all parts from the box in a cleared area and put them on the floor in front of you. Remove all
packing materials from your area and put them back in the box. Do not dispose the packing materials
until the assembly is completed.
Step 1
NOTE: Do not remove or damage the DEACL (111) located on the top of the main frame (1). The DE-
ACL (111) is for preventing the sensor wires to drop into the upright tube.
Step 1: Remove the carriage bolts (81) and nylon nuts (104) from the front stabilizer (2). There is a "R"
decal on one end of the front stabilizer (2). Attach the front stabilizer (2) onto the main frame (1) with
the "R" decal end at the right side and secure it with carriage bolts (81) and nylon nuts (104).
Step 2: Remove the buttn head bolt (94) from the bottom of the main frame (1). Insert the stopper tube
(48) through the main frame (1) and secure it with button head bolt (94).
Step 3: Insert the pedal shaft (44) through the main frame (1). Place the right foot pedal assembly
(46R) onto the right end of the pedal shaft (44) and place the left foot pedal assembly (46L) onto the
left end. Secure the foot pedals with button head bolts (94) and large washers (109) at both ends of the
pedal shaft (44).
NOTE: You need to use two allen wrenches to tighten the button head bolts (94) at both ends of the
pedal shaft (44) at the same time.
41