Operating Instructions; Control Panel With Slide Switch; Control Panel With Rotary Switch - Truma Trumatic E 4000 A Gebrauchsanweisung, Einbauanweisung

The safety shut-off device is also recommended for safety
reasons if caravans are being heated while driving.
For conducting the exhaust gas under the floor, the vehicle
floor must be sealed tight. There must also be three open
sides beneath the vehi-cle floor to ensure unhindered escape
of the exhaust gas (snow, aprons etc.).
Instructions for mobile heating appliances
Truma mobile cargo-hold heating units have been approved
by the professional associations. They are complete heating
appliances which are simply placed in the cargo hold with the
cargo as the need arises. The heaters are completely inde-
pendent and require no external connections of any kind.
Approval covers only original mobile cargo-hold heaters
manufactured by Truma. Reproductions by third parties have
not been approved! Truma refuses to give any guarantee of
safety and correct functioning in respect of a reproduction
mobile cargo-hold heater.
The use of the appliance in vehicles used for the transport of
hazardous goods is not permitted.
14

Operating instructions

Always observe the opera ting instructions and "Impor-
tant operating notes" prior to starting! The vehicle owner
is responsible for the correct operation of the appliance!
The installer or vehicle owner must apply the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, to a place in the vehicle where it is clearly visible to
all users (e.g. on the wardrobe door)! Ask Truma to send you
stickers, if necessary.

Control panel with slide switch

b
a = Slide switch
Heating – Off – Ventilation
b = Slide switch
High setting (large flame symbol)
Low setting (small flame symbol)

Control panel with rotary switch

c = "Heating" rotary switch
High setting (large flame symbol)
Low setting (small flame symbol)
d = "Off" rotary switch
e = "Ventilation" rotary switch
High setting (large symbol)
Low setting (small symbol)
Switching on the Heating
– Remove cowl cap.
– Turn on gas cylinder and open quick-acting valve in the gas
supply line.
– Adjust desired room temperature at rotary knob.
– Switching the heating on:
Control panel with slide switch
Set the switch (a) to Heating and switch (b) to the desired
output setting.
Control panel with rotary switch
Set the rotary switch to the desired output setting (c).
If the outside temperature is low, switch to high setting.
The Trumatic E heater has been tested and approved for
operation, also when the vehicle is moving. The burner
with fan assistance guarantees satisfactory operation, even
under extremely windy conditions. It may be necessary to ob-
serve respective, country-specific regulations for the operation
of liquid gas appliances when the vehicle is moving.
a
Trumatic E
e
d
c