Intended Use; Function Description; Operating Instructions; Start-Up - Truma VarioHeat Series Einbauanweisung

Function description

VarioHeat is s warm air heater for air circulation to heat camp-
ing vehicles quickly. The burner is fan-assisted, which ensures
that operation is problem-free, even when on the move.
The unit automatically selects the required operating level ac-
cording to the temperature difference between the setting on
the control panel and the current room temperature.
A boost function for quick heating and a night function for
low-noise operation are also available. The various fan set-
tings allow air circulation mode without heating.
The digital control panel can be used to select other func-
tions such as time switch or operation of a Truma air con-
ditioning system. Information on this can be found under
Truma CP plus VarioHeat digital control panel
This unit always starts up at the lowest setting. If this is not
sufficient to achieve the desired temperature inside the ve-
hicle, the unit switches to a higher operating level within a
few minutes.

Operating instructions

Always observe the operating instructions and the "Im-
portant operating notes" prior to starting! The vehicle
owner is responsible for correct operation of the appliance.
The installer or vehicle owner must affix the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, in a location in the vehicle where it is clearly visible
to all users (e.g. the wardrobe door). Missing stickers can be
requested from Truma.

Start-up

– Remove the cowl cover.
– Open the gas cylinder and the quick-acting valve in the gas
supply line.
– Switch on the heater, see.
Truma CP plus VarioHeat digital control panel or
Truma CP classic VarioHeat analogue control panel
If the appliance is not used for a long period, place on the
cowl cover and close the quick-acting valve in the gas supply
line and the gas cylinder.

Room temperature sensor

To measure the room temperature, an external room tempera-
ture sensor is located in the vehicle. The position of the sensor
is determined by the vehicle manufacturer depending on the
vehicle model. More information can be found in the operat-
ing instructions for your vehicle.
Figure 1
The temperature setting on the control panel depends on per-
sonal heating requirements and the design of the vehicle, and
must be determined individually.
Truma CP plus VarioHeat digital control
panel

Intended use

The Truma CP plus VarioHeat control panel is used to control
and monitor a Truma VarioHeat heater and / or a Truma
air conditioning system.
The following air conditioning systems can be operated with
the Truma CP plus VarioHeat
– Saphir compact
2
– Saphir comfort RC
– Aventa eco
– Aventa comfort
Truma CP plus VarioHeat for the
Truma air conditioning systems Aventa eco, Aventa comfort
(from serial number 24084022 – 04/2013), Saphir comfort RC
and Saphir compact (from serial number 23091001 – 04/2012)
The Truma CP plus VarioHeat is intended for installation in
caravans and motor homes.
And Truma CP plus VarioHeat CI-BUS for CI-BUS – not retrofittable.
1
From serial number 23091001. In combination with a
2
Truma VarioHeat heater, a "control panel cable coupling" is es-
sential between the air conditioning system and the heater. Order
the "control panel cable coupling" separately. Not in conjunction
with a TG 1000 sinus power inverter.
:
1
19