Maximum Tyre Width; Minimum Seatpost Insertion Length; Maximum Number Of Headset Spacers; Maximum Fork Length (Axle-To-Crown) - Orbea BLUE PAPER OIZ CARBON OIZ OMX 2023 Technisches Handbuch

12 | ORBEA
0 4 O I Z U SE WAR N I N G S
M AXI MUM TY RE WI DT H
guidelines when installing tyres on your bicycle.
However, the real measurements of the tyre circumference
and width may change from one manufacturer to another.
When installing a tyre other than that originally mounted
on your Orbea bicycle, check that there is at least 6 mm
between the top and the sides of the tyre and any part of
the frame or fork.
Also check the maximum and minimum tyre width that
width. See the wheels compatibility information on the
manufacturer's documentation.
Damage to the frame or components due to
the use of a tyre that does not comply with
these measurements is not covered by the
guarantee.
MINIMUM SEATPOST INSERTION
LEN GTH
Always follow the minimum insertion given
for the seatpost to be used or the frame. Fail-
ure to comply with these values can stress
the materials beyond the range for which
they were designed and cause breakages not
covered by the guarantee, as well as acci-
dents that can cause serious injuries.
TECHNICAL MANUAL
MAXIMUM NUMBER OF HEADSET
SPACERS
Never use more headset spacers below the
number of headset spacers that are accep-
table for use on an Orbea frame. Installing
more spacers than allowed can stress the
materials beyond the range for which they
were designed, which can cause accidents
and serious injuries.
MAX I MU M FO R K L E N GTH
( AX LE -TO - C R OWN )
Always follow the maximum fork length listed in the tech-
fork length refers to the distance between the fork axle
and the bottom part of the head tube (axle to crown).
L
BLUE PAPER OIZ CARBON OMX-OMR · 2 023
Failure to follow this requirement and ins-
talling forks with a length greater than the
yond its design characteristics, possibly re-
sulting in malfunctions of the material that
could cause accidents and serious injuries.
IN TENDED USE
The intended use of all models is ASTM Condition 3, which
provides for use under conditions 1 and 2, in addition to
technical and natural trails with bench cuts and jumps
up to 61 cm.
Use on this terrain requires technical skills and can lead to
injury for beginners.
For all ASTM categories, please refer to the user manual.
-
ORBEA | 13
EN