Lcd Icons; Standby Mode - Royal Catering Rcsi-16 Bedienungsanleitung

3.3.2.

LCD ICONS

h – – number of ice creams served
i – – ice cream cone thickness level / "AC.V"
– supply voltage
j – – ice cream bulk temperature
(model
k – – the icon shows that the ice cream
batch is being churned or ready for dispensing:
flashing – the ice cream batch is being churned;
steadily on – the ice cream batch has been churned
and is ready for dispensing
3.3.3.

STANDBY MODE

When the appliance is plugged into mains and turned on with the power switch (f), it is in standby mode.
The appliance beeps shortly. The LCD shows these indications:
a) – the digits show the number of dispensed ice cream cones
b) – the current supply voltage (such as AC 230V)
c) – the ice cream bulk temperature (model
d) – the icon comes on when the batch in the refrigerating bin is low.
3.3.4. ICE CREAM THICKNESS (HARDNESS) SETTINGS
The final ice cream bulk thickness setting has been factory defined. You can change the setting to suit your
ice cream recipe if needed. The procedure:
a) Press and hold the required key for 5 seconds: the "SUB" key to reduce the ice cream batch thickness
or the "ADD" key to increase the thickness. The appliance control system enters the setting mode.
b) The LCD display will cycle through the parameters.
c) Operate either of the both keys to reduce/increase the ice cream bulk thickness (d / e).
d) The setting is changed in 0.1 increments. The thickness can be adjusted to anywhere within 2.0 and 6.0
for 230V.
e) Having input the thickness setting, wait for the appliance to store it in memory and show the main
readings on the LCD.
Model Factory hardness setting
3.3.5. PRE-COOLING TEMPERATURE SETTINGS
a) CAUTION! The pre-cooling mode is supported in model
temperature thresholds selectable for the refrigerating system. First, the low temperature threshold is
configured, followed by the high temperature threshold.
b) CAUTION! When the appliance reaches the low temperature threshold while running, the refrigerating
system will stop.
c) CAUTION! When the appliance reaches the high temperature threshold, the refrigerating system will
restart.
d) Start the pre-cooling. Do this by pressing and holding the batch pre-cooling / cooling level selector key
(g) for approx. 5 seconds.
EN
l –
(drive unit) is running
m –
cooling is running / the appliance keeps the batch
) cold (model
n –
the refrigerating bin is low
Suggested hardness setting range in normal use
5.0
5.0
5.0
4.0
– the icon comes on when the stirrer
– the icon comes on when pre-
– the icon comes on when the batch in
)
2.0 – 5.0
2.0 – 5.0
2.0 – 5.0
2.0 – 4.0
. There are two
)