Viewing The Technical Data Of The Preselected Vehicle - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
Make of the selected
Model of the selected
7.4.2

Viewing the technical data of the preselected vehicle

Once the vehicle has been selected (Para. 7.4.1), a screen opens with the measurements and tolerances of the angles (minimum,
central and maximum value) and other additional data, such as the rim diameter, wheelbase, track and any load and tank conditions
(*).
The screen with the measurements and tolerances can be displayed as per the image below: with a single column of corresponding
values for the left and right side.
1
2
3
1 Any load and tank conditions
2 Wheelbase and track values in mm
Circle diameter:
3
Note: it is also possible to change the displayed diameter by pressing on the circle symbol.
4 Front axle angle tolerances
Tolerances of rear axle angles
5
Note: use the scroll to view all the data.
The measurements and tolerances can be displayed as in the screen above: with a single column of consistent values for the left and
right sides.
EN-22 2015-M364-0
vehicle
vehicle
Tap this key to display the measurements with the central value and the overall tolerance "±".
In the "System configuration" menu (para. 7.2) it is also possible to set the separate display of left and
right data (some vehicles may have slightly different tolerance values for the left and right sides).
ROT.R51HD - SPA.BA6HD - RAV.TD600
4
5