Push Run-Out - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
7.6.2

Push run-out

1
Vehicle push direction (back)
1
2 Point of arrival of vehicle at 30°
It is advisable to follow the visual instructions that appear on the screen very carefully.
• RELEASE the sensors so that they are free to swing with the movement of the wheel.
• Wait for the sensors to stop swinging and start moving the vehicle back, very slowly, until the wheel has performed a 30° rotation.
This rotation can be observed on the spokes of the 3-point clamps.
Tap the centre
key on one of the
sensors at the
arrival point.
Tap this key during the run-out preparation step.
The following screen appears.
ATTENTION!
This procedure can be carried out correctly only if 3-point clamps are used, observing a 30° rotation
with the position of the stokes.
ROT.R51HD - SPA.BA6HD - RAV.TD600
End position (30°
rotation)
2
Initial
position
2015-M364-0 EN-31