Dover VSG ROT.R51HD Übersetzung Der Originalanleitung Seite 106

TABLE OF CONTENTS
• Tap the centre key: the word "STOP" will appear for about three seconds, which is the time it takes for the program to acquire
the measurements, then the program shows the following screen.
Tap the centre
key on one of the
sensors at the
arrival point.
Move the vehicle forward again until the wheel has performed
another 30° forward rotation (final point) - the clamp spoke
is in the vertical position again.
Move the vehicle forward again, until the arrow of the vehicle matches the arrival point (return to the starting position in the centre
of the plates), "STOP" is displayed for a few seconds, the measurements are acquired. The push run-out procedure has been performed.
EN-32 2015-M364-0
To repeat the operation, having already advanced in the program, it is possible to return to this page
by tapping this key and then repeat the operations described above.
When the run-out has been performed, the program automatically proceeds to the next step.
ROT.R51HD - SPA.BA6HD - RAV.TD600
"STOP" is
displayed for
about three
seconds.
End position