Handling And Pre-Installation; Installation; Electrical Connection - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
6

HANDLING AND PRE-INSTALLATION

6.1

INSTALLATION

ATTENTION
• Do not install the equipment in places where persistent conductive dust is present (pollution degree equal to or
greater than 3).
• Install the equipment in indoor areas, sufficiently lit and protected from atmospheric agents.
WARNING
• Before positioning the equipment, make sure that the chosen location is suitable for the local regulations Local in
force on workplace safety and check the minimum distances from walls or other obstacles.
• The enclosure's electrical socket must be free from obstacles and accessible in an emergency.
WARNING
• Risk of fire and explosion! To reduce this risk, the machine must be used only in places where there is no risk of
fire or explosion. This product must be installed and used only within licensed workshops.
6.2

ELECTRICAL CONNECTION

ATTENTION
Before connecting the machine, carefully check that:
• the characteristics of the power line correspond to the requirements of the machine indicated on the relative plate;
• the earthing line is present and that it is adequately sized (section greater than or equal to the maximum section
of the power cables);
• all the components of the electrical line are in good condition.
WARNING
• Connect the machine to the mains by inserting the supplied 3-pin plug (210V - 240V AC) into the wall socket. If the
plug supplied is not suitable for the one on the wall, equip the machine with the plug in accordance with the local
laws and current standards and regulations. This operation must be performed by experienced and qualified
personnel.
ROT.R51HD - SPA.BA6HD - RAV.TD600
2015-M364-0 EN-17