Dover VSG ROT.R51HD Übersetzung Der Originalanleitung Seite 104

TABLE OF CONTENTS
The screen with the "STOP" symbol appears again for about three seconds. After acquiring the measurements, the program automatically
continues and displays the following screen accompanied by a check mark, indicating that for that wheel the procedure is complete.
However, the procedure can be repeated by pressing the centre key of the detection head in question again. When the run-out has
been performed on all wheels, the program automatically proceeds to the next step.
Wheel on which
the procedure
was carried out.
NOTE:
the various steps can be followed by monitoring the red LED on the keypad of each sensor:
the red LED flashes when the wheel needs to be rotated; the red LED goes out when one of the points is being sampled; the red LED
is on steady when the procedure is completed.
In the system configuration, it is possible to define that the procedure needs to be performed on 3 points instead of 2, in which case
the wheel is rotated 3 times by 120° instead of 2 times by 180° as explained above.
EN-30 2015-M364-0
ROT.R51HD - SPA.BA6HD - RAV.TD600