Installation Requirements; Minimum Requirements Of Installation Site; Transport And Packaging - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
5

INSTALLATION REQUIREMENTS

5.1

MINIMUM REQUIREMENTS OF INSTALLATION SITE

Check that the place where the machine will be installed complies with the following specifications:
- use of the wheel aligner is only permitted in indoor locations where there is no risk of explosion or fire.
- sufficient lighting (but not in an area with glare or bright lights). Reference standard EN 12464-1;
- place not exposed to weathering;
- place with suitable air exchange;
- pollutant-free environment;
- noise level below the current regulatory requirements at ≤70 dB (A);
- room temperature: min. 5 ° - max 55°;
- the workplace must not be exposed to hazardous movements due to the simultaneous operation of other machines;
- the place where the machine is installed must not be used to store explosive, corrosive and/or toxic materials;
- the minimum dimensions of the area where the enclosure can be placed are 2500 x 2500 mm;
- the installation layout must be selected taking into account that the operator must be able to see the entire device and surrounding
area from the control station. He/she must prevent the entry of unauthorised persons or objects in this area, which may be a source
of danger.
All installation works concerning external connections and power supplies (electrical, in particular), must be carried out by professionally
qualified personnel.
The installation must be carried out by authorised personnel following any special instructions included in this booklet; in case of
doubt, contact the VSG ITALY s.r.l. authorised service centres or technical support.
5.2

TRANSPORT AND PACKAGING

The equipment is supplied packed in a box secured onto a pallet to facilitate transportation.
ATTENTION
• To transport the machine to the point where it will be installed, use lifting and transport means such as forklifts or
lifters equipped with forks.
• The equipment must be stored and packaged in indoor areas not exposed to weathering such as rain or sub-zero
temperatures, and preferably in a dry and airy location.
• The packaging must never be overturned or arranged horizontally, the pallet must always rest on a flat and solid
surface, do not stack other packages on top, the arrangement must allow easy reading of the indications.
WARNING
• Always wear gloves and safety shoes during unpacking.
Be sure to have received all the standard parts listed above.
The packaging material (plastic bags, polystyrene, nails, screws, wood, etc.) must be kept collected and disposed of according to the
regulations in force, with the exception of the pallet, which could be reused for subsequent handling of the machine.
EN-16 2015-M364-0
ROT.R51HD - SPA.BA6HD - RAV.TD600