Sensors - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
At the first start-up, it is necessary to perform the activation
procedure:
• enter the codes indicated in the accompanying document.
• Then enter the data relating to the user, to start the
manufacturer's warranty period.
Keep the document with the codes, which will be needed in the
event the App is uninstalled and reinstalled again.
3.6

SENSORS

The sensors of the CCD equipment do not require the connection of any cable or lanyard for angle measurement.
The sensors consist of infrared data transmitters/receivers and CCD-type transducers with infrared emission focal point. All
characteristic angles of both vehicle axles are checked by 8 CCD sensors with infrared measurement.
The front sensors communicate with the control device (tablet), using compatible Bluetooth modules.
The data from the rear sensors is transmitted/received by passing through the front sensors, using infrared transmission. Data
transmission between the infrared sensors is effective even in critical lighting conditions.
The power supply comes from long-life 6 V rechargeable batteries. The batteries of the front and rear sensors are recharged using
the special charging stands.
ATTENTION
• The rechargeable batteries are contained in a plastic housing. If there are any signs of corrosion, swelling
of the container or damage to the container, the battery must be removed immediately and replaced with
a new, undamaged, original one.
• The batteries must be handled with care. The user must wear protective gloves.
• Do not open or tamper with the battery pack and its shell.
• Use only the supplied battery pack.
• A label with notes and warning symbols is affixed to each battery
EN-10 2015-M364-0
ROT.R51HD - SPA.BA6HD - RAV.TD600