General Safety Regulations; Indications Of Residual Risks; Safety Labels And/Or Stickers; Operator Training - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS
4

GENERAL SAFETY REGULATIONS

4.1

INDICATIONS OF RESIDUAL RISKS

The wheel aligner is produced in compliance with strict standards in order to meet the requirements of the relative directives.
The risk analysis was accurately conducted and the hazards have been eliminated as far as possible.
Any residual risks are highlighted in this manual and on the machine by means of safety signs and symbols.
4.2

SAFETY LABELS AND/OR STICKERS

Labels and stickers are affixed to the wheel aligner, necessary to identify the machine, its capacity, the instructions and the electrical
system.
In the event these labels and/or stickers are damaged, they must be replaced by submitting a request to VSG ITALY s.r.l.
4.3

OPERATOR TRAINING

Only specially trained and authorised personnel may use the equipment. In order to ensure optimal machine management and efficient
operations, the designated personnel must be properly trained to learn the necessary information in order to achieve an operating
mode that is in line with the instructions provided by the manufacturer.
For all doubts regarding use and maintenance of the machine, refer to the instruction manual and, if necessary, contact VSG ITALY
s.r.l. authorised service centres or technical support.
4.4

FITNESS FOR USE

During the operation and maintenance of this machine it is absolutely essential to comply with all the safety and accident-prevention
regulations in force and with the European Directives 89/686/EEC, UNI EN ISO 20345, UNI EN ISO 13688: 2013, EN 388 and EN 420.
Codice 20925
70 mm
WARNING
Materiale: 3M lucido + plasti cazione
"Read the
Misure: 20 mm x 70 mm
"Disposal"
1 999916311 DISPOSAL LABEL
1 999930530 WARNING LABEL "Read the manual"
FUSE LABEL
2 999930450
POWER LABELS
3 999930520
DOUBLE FUSE LABEL
3 999930460
4 999930470 MAXIMUM POWER LABEL
6 5
INDICE INDICE
DESCRIZIONE
POSIZ.
MODIFICA AGGIORNAMENTO
LABEL
manual"
PLATE
EM / MOD N° DATA DISEGNATO DA
LFisichella -
-
04/12/2023
TAVOLA NOTE:
-
1
GRUPPO TRATTAMENTO
- -
MATERIALE FORMA MATERIALE COMPOSIZIONE CHIMICA
-
DESCRIZIONE RWA5100HD
DOCUMENTO DI PROPRIETA' DI VEHICLE SERVICE GROUP ITALY S.r.l. OGNI USO, RIPRODUZIONE E DIFFUSIONE DEVE ESSERE AUTORIZZATA
4 3
FORM A2
ROT.R51HD - SPA.BA6HD - RAV.TD600
EMISSIONE
MODIFICA
DATA
MODIFICA
APPROVATO DA SCALA:
1: 1 0
FINITURA : MASSA . CLASSE
0,00 g -
-
SOSTITUISCE IL :
-
CODICE
Figurino
2 1
FIRMA
H
G
F
FUSE LABEL
"Circuit
E
protection"
Battery charger
D
MISCELLANEOUS LABELS WITH
DATA AND WARNINGS ON THE
GENERAL POWER SUPPLY
C
B
A A
I.A.
2015-M364-0 EN-15