Front Axle Adjustment - Dover Vsg Rot.r51Hd Übersetzung Der Originalanleitung

TABLE OF CONTENTS

7.13 FRONT AXLE ADJUSTMENT

The recommended angle adjustment order is as follows: CASTER - CAMBER - TOE.
NOTE:
In this step, the Caster values are "FROZEN" (they appear with a superimposed grid).
To "unfreeze" these values, it is necessary to:
• with key move the "Adjustment" selection to the caster values and then press
a superimposed grid).
Once the caster values have been adjusted, or if they have not been adjusted and are considered correct, it is advisable to "Refreeze"
these values by pressing
Then adjust the front axle.
Caster measurements
"Frozen" values.
Front camber
measurements
Front partial toe
measurements.
NOTE:
The PARTIAL TOE values can be displayed added together in order to obtain the TOTAL TOE.
Press Shift+F5 to alternate the PARTIAL TOE and TOTAL TOE displays.
Tap this key on the screen of para. 7.12 after preparation for adjustment is complete.
again.
Tap this key to run the "Jack-Hold" procedure, adjustment with the wheels raised (Para. 7.13.2).
Tap this key to repeat the steering procedure (Para. 7.9)
Tap this key to adjust the front toe with the wheels steered
Tap this key to go to the DIAGNOSIS and ADJUSTMENT data summary (Para. 7.14).
ROT.R51HD - SPA.BA6HD - RAV.TD600
(they will now appear without
2015-M364-0 EN-37