Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
Fault
Saw blade is loose after the motor is switched
off
Motor does not start
Incorrect turning direction for motor
Motor not supplying power, switches itself off
automatically
Burnt points on the cutting area
Burnt points on the cutting area during trans-
verse cuts
Decreasing saw power with full motor speed
•
Occasionally, clean wood residues and sawdust from the guard casing of
the saw.
•
Occasionally, oil all moveable parts.
•
Always keep the machine table free from resin.
•
required, using dry lubricant, treat the surface of the guide rail as well as
the underneath of it.
Belt Tension
•
Check the belt tension after the first 1-2 hours of operation.
•
In order to do this, remove the cover fitted to the side of the frame.
•
To check the belt tension, press down on the belt with your thumb using
medium pressure. The belt should flex about 2-3 mm.
•
Adjust the belt tension if required. To do this, loosen the 4 hexagon bolts
(1). Turn the motor anti-clockwise until the belt is tight.
•
Re-tighten the 4 hexagon bolts (1).
•
Re-fit the cover to the frame.
Trouble shooting
Possible cause
Fixing nut not tight enough
1.
Mains fuse blown
2.
Extension cable defectivet
3.
Connection to the motor or switch not
OK
4.
Saw blade protective cover not closed
(limit switch)
1.
Capacitor defective
2.
Incorrect connection
1.
Overload due to blunt saw blade
2.
Thermal protection tripped
1.
Blunt saw blade
2.
Incorrect saw blade
1.
Lengthwise aligning stop not parallel
to the saw blade
2.
Sliding carriage not parallel to the saw
blade
Belt loose
37
Remedy
Tighten fixing nut
1.
Check mains fuse
2.
Check extension cable, do not con-
tinue to use defective cables, have
them repaired by a professional.
3.
Have this checked by an electrician
4.
Close saw blade protective cover
1.
Have this replaced by an electrician
2.
Phase rotation
1.
Insert sharpened saw blade
2.
Can be switched back an again
after cool-down time
1.
Insert sharpened saw blade
2.
Insert saw blade for longitudinal
cuts
1.
Adjusting the lengthwise aligning
stop
2.
Align sliding carriage with the saw
blade
Tighten belt
D GB
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
Fehlerbehebung
