Scheppach Forsa 3.0 Bedienungsanleitung Seite 38

Workpiece jammed between saw blade and
lengthwise aligning stop
Sliding carriage does not run
Height adjustment difficult to move
Angle adjustment difficult to move
Workpiece jammed between saw blade and
lengthwise aligning stop
90°/45° position of the saw blade incorrect
Riving knife not aligned with saw blade
In the event of faults that you are unable to rectify yourself, then please contact the scheppach customer service department.
E-Mail: service@scheppach.com
Tel.: 00 49/82 23/40 02-99
D GB
Lengthwise aligning stop not parallel to the
saw blade
1. Lock not released
2. Guide unit dirty
Threaded spindle contaminated with
sawdust
Toothed segments and rack dirty
Lengthwise aligning stop not parallel to the
saw blade
Hexagonal screws on the toothed seg-
ments have moved out of place
Riving knife not set properly
38
Check the setting of the lengthwise
aligning stop
1. Release lock
2. Clean guide unit
Clean threaded spindle and treat with
dry lubricant spray
Clean toothed segments and rack and
treat with dry lubricant spray
Check the setting of the lengthwise alig-
ning stop and readjust
Readjust hexagonal screws on the too-
thed segments
Readjust riving knife