Scheppach Forsa 3.0 Bedienungsanleitung Seite 29

1
2
2
1 1 1 1 1
3
4
7
5
6
8
9
11
10
2
3
1
3
3
Assembling the lengthwise aligning stop
• The lengthwise aligning stop has already been completely fitted.
• Place the lengthwise aligning stop (1) on the guide rail and secure it with
the clamping levers (2).
Assembling the table extension
Parts required:
5. 1x tabletop
6. 1x support bracket, right
7. 1x support bracket, left
8. 6x hexagonal nut M8
9. 10x washer 8
10. 1x hose bracket
11. 11x hexagonal screw M8x16
12. 1x retainer plate
13. 1x hex nut M6
14. 1x washer A6.4
15. 1x wing screw M6
• Required tool: Open-ended spanner, size 13
1
• Screw the right support bracket (1) and the left support bracket (2) onto the
frame of the machine with the 4 hexagonal screws M8 (3).
Place the tabletop (1) down on the two support brackets.
•
• Position 2: Screw down the tabletop hand-tight on both sides with the 4
2
hexagonal screws M8x16; 8 washers and 4 hexagonal nuts.
• Position 3: Screw the tabletop hand-tight to the machine table with 2 hexa-
gonal screws.
Align the table extension (1) to the machine table with a steel rule (2) or a
•
straight edge.
• Tighten up all the screws.
2
1
29
D GB