Troubleshooting - Scheppach Lata 7.0v Originalanleitung

Four-jaw chuck Ø 125 mm
Extension console
Jaw chuck protection
Problem Possible Cause
a) No electricity
Motor doesn't start
b) Defective switch, condenser
c) Defective extension cord
Drilled holes become Headstock and tailstock are not parallel.
larger than the drill bit
Work piece flatters a) Working piece becomes loose
while working
b) Work piece is not properly centered
c) Rotational speed is too high
Tool rest or tailstock Setting the eccentric clamping
cannot be clamped
All manuals and user guides at all-guides.com
7400 7400
8800 2756
8800 2758
Trouble shooting
while working
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consuma-
bles.
Wear parts*: Carbon brushes, v-belt
* Not necessarily included in the scope of delivery!
Help
a) Check fuse
b) Have an electrician inspect unit
c) Unplug cord, inspect and replace, if
necessary
Set up headstock according to the tailstock
tip. Insert carrier into the drilling spindle for
this and position the tailstock with tip up to a
distance of approx. 1°mm.
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Return the hexagonal nut at the bottom side
about ½ rotation with the socket spanner
english 17