Ambu aScope 5 Broncho Bedienungsanleitung Seite 9

No. Part
Working channel port
3
Working channel
4 Biopsy valve
5 Suction connector
6 Suction button
Endoscope buttons
7
1 & 2
8 Rotation control ring
9 Tube connection
Insertion cord
10
Insertion portion
11 Bending section
12 Distal tip
13 Display unit connector
14 Cable
15 Protective handle cover
16 Protective pipe
17 Introducer
3. Use of aScope 5 Broncho
Numbers in gray circles below refer to illustrations on page 2.
3.1. Preparation and inspection of aScope 5 Broncho
Lubricate the insertion cord with a water based medical grade lubricant to ensure the lowest
possible friction when the endoscope is inserted into the patient.
Visual inspection of the endoscope 1
1. Check that the pouch seal is intact. 1a
2. Make sure to remove the protective elements from the handle and from the insertion
cord. 1b
3. Check that there are no impurities or damage on the product, such as rough surfaces,
sharp edges or protrusions that may harm the patient. 1c
4. Turn on the Ambu display unit. 2a 2b
Refer to the Ambu display unit's Instructions for Use for preparation and inspection of the Ambu
display unit. 2a 2b
Function
Allows for instillation of fluids and insertion of
endotherapy instruments.
Can be used for instillation/aspiration of fluids and
insertion of endotherapy instruments.
Attached to the working channel port. Endotherapy
instruments can be inserted or a syringe can be attached.
Allows for connection of suction tubing.
Suction when pressed.
Depending on the settings in the Ambu display unit,
the two remote switches allow for direct activation on
handle of four different functionalities, such as image
and video capturing, ARC and zoom.
Allows for rotation of the insertion cord
during procedure.
Allows for fixation of tubes with standard connector
during procedure.
Flexible airway insertion cord.
Same as insertion cord.
Maneuverable part.
Contains the camera, light source (two LEDs), as well as
the working channel exit.
Connects to the connector port on the Ambu display unit.
Transmits the image signal to the Ambu display unit.
Protects the control lever during transport
and storage. Remove before use.
Protects the insertion cord during transport
and storage. Remove before use.
Facilitates introduction of Luer Lock syringes.
9