Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.1.1
Connecting and switching on the machine
1.
Remove the water tank and clean it thoroughly (see Chapter 11.5,
"Cleaning the water tank").
2.
Fill the water tank with water and insert it back into the machine (see
Chapter 9.4, "Filling the water tank with water").
3.
Plug the mains plug into the socket.
4.
Press the on/off button (2, Fig. 5).
The LED ring of the on/off button lights up and the "Fill" icon appears on
¾
the display.
8.1.2
Filling the boiler with water (fill mode)
1.
Place a receptacle under the brew group (3, Fig. 5). The opening of the
receptacle should be at least as big as the brew group.
2.
Press one of the brew buttons (4, 5, Fig. 5).
The LED of the brew button that was pressed flashes and the pump
¾
starts to fill the brew boiler.
3.
Wait for at least 30 seconds.
When water comes out of the brew group, this means that the brew
¾
boiler is full.
4.
End the brewing process by pressing the flashing brew button.
The "Fill" icon disappears from the display and the steam boiler is filled.
¾
5.
Wait until you cannot hear any more pump noise.
The steam boiler is full and the machine starts to heat up the boilers.
9
The "Heating Up" icon appears on the display. After the boilers have
heated up, the brew temperature is shown on the display. The machine
is ready to use.
8.1.3
Rinsing the machine
Rinse the machine with 2 - 3 water tank refills before preparing your first
espresso:
1.
Switch off the heated-up machine using the on/off button.
The LED ring goes out.
¾
2.
Drain water out of the machine via the hot water wand (see Chapter 11.6,
"Emptying the steam boiler").
3.
Refill the water tank (see Chapter 9.4, "Filling the water tank with water")
4.
Switch on the machine using the on/off button.
The LED ring lights up.
¾
5.
Wait until the brew temperature is shown on the display.
6.
Repeat this procedure three times.
7.
With the machine switched on, empty the remaining quantity of water
via the brew group.
EN - 94
MOVE_BA_V1.0
Werbung
