Profitec MOVE Bedienungsanleitung Seite 103

Observe the following when not using the silicone attachment:
• The opening of the cup should be as wide as the filter used. Otherwise,
espresso may pour out at the sides.
Proceed as follows when preparing espressos:
1. Insert the desired filter in the portafilter (see Chapter 9.6, "Inserting the
silicone attachment and filters in the portafilter").
2. Fill the filter with the desired quantity of ground coffee.
3. Press and compact the ground coffee evenly using the tamper (see
Chapter 9.5, "Pouring ground coffee into the portafilter and pressing
(tamping)").
4. Insert the portafilter in the brew group (see Chapter 9.7, "Inserting the
portafilter in the brew group").
5. Place a suitable empty cup under the portafilter depending on the cup
filter.
6. Press one of the brew buttons.
The LED of the brew button that was pressed will start to flash and the
9
automatic espresso preparation process will begin. The timer for the
brew time will start on the display. If pre-infusion is set and has been
activated for the brew button (see Chapters 10.3.4, "Pre-infusion" and
10.3.5, "Brew settings - setting via the menu"), the timer is interrupted
after the active pre-infusion time has elapsed and "---" appears on the
display. After the passive pre-infusion time has elapsed, the timer for
the brew time will appear again on the display. After the set brew time
has elapsed, the espresso brewing process is ended. Residual water is
drained into the drip tray and residual pressure released via the residual
water outlet of the brew group.
7. The brewing process can be ended at any time by pressing the flashing
brew button.
The brewing process is complete. Both buttons light up and the current
9
brew temperature appears on the display after a few seconds.
If the set brew time is not sufficient, the automatic brewing can be manually
extended. The maximum duration for manual brewing is 60 seconds.
1. During automatic brewing, press the second brew button.
This brew button starts to flash while the LED of the other brew button
¾
goes out. The icon for manual brewing appears on the display.
2. To end the brewing process, press the flashing brew button again.
The brewing process is complete. The brew temperature appears on the
9
display and both brew buttons will light up.
EN - 104 MOVE_BA_V1.0