Angelo Po 0N0TPG Bedienungshandbuch Seite 45

USE AND OPERATION
Hotplate control knob: to switch on, switch
A)
off and adjust the hotplate burner.
B
Full power
marker
Switching on the appliance
IMPORTANT:
griddle is switched on, wash the plate to
remove the protective grease and any dirt,
then switch on the appliance and preheat
it for about 1 hour at the minimum power
setting.
Turn on the appliance's circuit breaker to
)
connect it to the electrical mains.
Turn on the gas supply tap.
)
Press the knob (A) and turn it anti-clockwise
)
(pos. B), while keeping button (B) pressed, to
light the pilot light.
Keep the knob pressed for about 15 sec. to
)
prime the thermocouple. The pilot light can
also be lit by hand through the hatch (C).
Press the knob (A) and turn it anti-clockwise
)
(pos. 2) to light the burner at the maximum
power setting.
3320091_ut_GB
DESCRIPTION OF CONTROLS
Pilot light marker
Minimum
power marker
SWITCHING THE PLATE BURNER ON AND OFF
The fi rst time the
Ignition button: to light the pilot light of the
B)
hotplate burner.
Off marker
A
D
A
ENGLISH
A
B
C
B
A
1
3
2
19